Products : Grout : Caulk & Sealant : Ceramic Tile Caulk

Ceramic Tile Caulk

Our ceramic tile caulk is for caulking around sinks, tubs, showers and where tile meets tile or another surface. Also adheres bath fixtures and loose tile. Do not use to install grab bars. Maximum joint width and depth should not exceed 1/4" (6 mm). Do not use in areas with constant water exposure. For interior use only.

  WHERE TO BUY Not all products are sold at all stores. Please call the distributor to ensure product availability.
Have a question?


Key Features

  • Use around tubs and sinks
  • Use where horizontal and vertical surfaces meet
  • Siliconized for ease of use


  • For caulking around sinks, tubs and showers
  • Adheres bath fixtures and loose tile.
  • For joint up to ¼” (6mm) wide and deep
  • For interior use.
  • Available in sanded and non-sanded versions to match grout texture.
  • Mold and mildew resistant


Composition of Product

Siliconized acrylic latex resins with fine fillers and colored pigments

Environmental Consideration

Custom® Building Products is committed to environmental responsibility in both products produced and in manufacturing practices. Use of this product can contribute towards LEED® v3 certification:

  • Up to 2 points towards MR Credit 5, Regional Materials
  • Up to 1 point towards IEQ Credit 4.1, Low-Emitting Materials – Adhesives & Sealants

Suitable Tile Types

  • Around tubs, showers and sinks
  • Bonds bath fixtures and loose tiles

General Surface Prep

USE CHEMICAL-RESISTANT GLOVES, such as nitrile, when handling product.

Health Precautions

Contains Petroleum Distillates. If ingested, do not induce vomiting, call a physician immediately. Use with adequate ventilation. Nonflammable. KEEP OUT OF REACH OF CHILDREN. DO NOT TAKE INTERNALLY. AVOID EYE CONTACT.

Limitations to the Product

  • Do not use to install grab bars.
  • Maximum joint width and depth should not exceed 1/4"" (6 mm).
  • Do not use in areas with constant water exposure

Application of Product

Surfaces should be clean, dry and free of all contamination. Place cartridge in standard caulking gun. Cut tip off nozzle on a slant to desired opening size and completely fill joints with caulk. Smooth with wet finger. Clean off excess caulk with soap and water before it cures. Do not apply when temperature falls below 50°F (10°C).

Curing of Product

Minimum 24 hours before exposing to water. Cure time may be extended, depending on caulking thickness and ambient conditions.

Cleaning of equipment

Clean tools with water before material dries.


Replace cap after each use. Store away from extreme heat or cold. Keep from freezing.

Product Maintenance

Clean with a neutral cleaner such as Aquamix AquaKleen or Tilelab Grout & Tile Cleaner

Ordering Information


10.5 oz (310 ml) cartridge

Coverage Chart

Size Coverage
10.1 oz. (300 mL) 24 lineal feet (7.3 M) of 1/4" x 1/4" (6 x 6 mm) joint

© 2021 Custom Building Products. All Rights Reserved. Privacy