PROCURVE™

Curved designs are a snap with ProCurve™, a flexible profile for tile installations or other designs with wavy, meandering edges. Let your imagination run wild — ProCurve™ gives you the freedom to bend, curve, and twist without sacrificing edge protection or an aesthetic finish.

  WHERE TO BUY Not all products are sold at all stores. Please call the distributor to ensure product availability.
Have a question?

Features/Benefits

Benefits

  • Easy to shorten and fit on-site
  • Protects edges of adjacent floor and wall coverings
  • Can be bent on-site for non-linear covering separations

Documents

TDS Documents

Technical Data Sheet

Technical/Installation

Conformance to Building Codes

Installation must comply with the requirements of all applicable local, state and federal code jurisdictions.

Environmental Consideration

Custom® Building Products is committed to environmental responsibility in both products produced and in manufacturing practices. Use of this product can contribute towards LEED® v3 certification:

  • Up to 1 point towards IEQ Credit 4.3, Low-Emitting Materials - Flooring Systems

Limitations to the Product

  • Aluminum and brass profiles are for use in interior applications only. Stainless steel profiles may be used in exterior applications.
  • Consult CUSTOM technical services for installations in areas where harsh chemicals may be used.
  • Contact CUSTOM technical services for installations in pools and water features.
  • Ambient temperature, surfaces and materials should be maintained at a temperature between 50° F (10° C) and 95° F (35° C) during application.

Application of Product

Measure the tile thickness and approximate mortar depth making sure that the profile will provide proper protection; the upper edge of the profile must always be at the same height or lower (up to 1/32" lower) than the adjacent tile edges. Check the profile for damage – use only undamaged profiles. Use suitable clamps, saws or cutting devices as well as personal protective equipment for cutting and deburring the profile. The profile may be adjusted by hand or using templates when bending or making curves.

Spread thin-set mortar on the substrate where the profile is to be placed with a notched trowel. Place the stamped fitting strip of the profile into the thin-set mortar and align with the predetermined edge, then cover stamped fitting strip completely with additional thin-set mortar. Make sure to embed the profile in fresh setting material; retrowel or refresh if it has skimmed over prior to the installation of the profile. The tile adjacent to the fitting strip must be placed so it is completely embedded into the thin-set mortar over the stamped fitting strip. The tile should be even or slightly above the edge of the profile. The space between the profile and adjacent tile should be 1/16" - 1/8" wide. Make sure that the joint between the floor covering and the profile is completely filled with grout.

Clean away any mortar or grout residue from the sides of the profile immediately, using clean water and a non-abrading sponge pad or cloth. Do not allow the mortar or grout to dry on the surface of the profile.

ProCurve

Storage

Store in a cool dry area.  Protect from damage that may bend or twist the profile.

Product Maintenance

Use TileLab Grout and Tile Cleaner or Aqua Mix Concentrated Stone and Tile Cleaner and a sponge or soft cleaning cloth to clean the surface of the profile. Do not use abrasive cleaners, as they will scratch the surface.

© 2016 Custom Building Products. All Rights Reserved.