ALERT: Scheduled website maintenance underway. Some functions may be temporarily unavailable.

Products : Profiles & Transitions : Decorative Profiles : PRODECOR™ T

PRODECOR™ T

ProDecor™ T offers an attractive and practical way to bridge gaps between floor treatments of the same height, such as tile, stone, parquet, and laminate. This profile also helps conceal inconsistent joints, offering functional aesthetics and excellent protection of outer edges.

  WHERE TO BUY Not all products are sold at all stores. Please call the distributor to ensure product availability.
Have a question?

Features/Benefits

Benefits

  • Easy to fit and adjust on-site
  • Works with a wide variety of covering heights
  • Can be fitted in an open joint after floor coverings have been installed

Documents

TDS Documents

Technical Data Sheet

Technical/Installation

Conformance to Building Codes

Installation must comply with the requirements of all applicable local, state and federal code jurisdictions.

Environmental Consideration

Custom® Building Products is committed to environmental responsibility in both products produced and in manufacturing practices. Use of this product can contribute towards LEED® v3 certification:

  • Up to 1 point towards IEQ Credit 4.3, Low-Emitting Materials - Flooring Systems

Limitations to the Product

  • Aluminum profiles are for use in interior applications only. Stainless steel profiles may be used in exterior applications.
  • Consult CUSTOM technical services for installations in areas where harsh chemicals may be used.
  • Contact CUSTOM technical services for installations in pools and water features.
  • Ambient temperature, surfaces and materials should be maintained at a temperature between 50° F (10° C) and 95° F (35° C) during application.

Application of Product

Measure the tile thickness and approximate mortar depth making sure that the profile will provide proper protection; the upper edge of the profile must always be at the same height or lower (up to 1/32" lower) than the adjacent tile edges. Check the profile for damage – use only undamaged profiles. Use suitable clamps, saws or cutting devices as well as personal protective equipment for cutting and deburring the profile.

Use caulk to fill the cleaned joint chamber to the height of the covering up to 50-75%. Use backfill cord if necessary. Apply a fine bead of caulk to the left and right of the lip on the underside of the PRODECOR T profile. Next, insert the profile in the filled joint with the vertical lip. The silicon or acrylic that escapes under the profile must be wiped away cleanly and the edges must be smoothed off using a suitable smoothing agent (alternately, mask off adjacent surfaces and the upper side of the profile in advance to protect against soiling). Ensure that the side flanks of the profile rest completely against the edges of the covering.

Clean away any mortar or grout residue from the sides of the profile immediately, using clean water and a non-abrading sponge pad or cloth. Do not allow the mortar or grout to dry on the surface of the profile.

ProDecor T

Storage

Store in a cool dry area.  Protect from damage that may bend or twist the profile.

Product Maintenance

Use TileLab Grout and Tile Cleaner or Aqua Mix Concentrated Stone and Tile Cleaner and a sponge or soft cleaning cloth to clean the surface of the profile. Do not use abrasive cleaners, as they will scratch the surface.

© 2016 Custom Building Products. All Rights Reserved.