Products : Profiles & Transitions : Cove Profiles : PROCOVE™ A


ProCove™ A is designed to provide smooth transitions between tiled walls, floors or countertops with hard or soft surface finishes.

  WHERE TO BUY Not all products are sold at all stores. Please call the distributor to ensure product availability.
Have a question?



  • Easy to fit with the installation of most surface coverings
  • Can be shortened to length on-site
  • Designed to take impacts along the edges of floors and wall coverings
  • Ideal for transitioning from tile surfaces to other floor coverings


Conformance to Building Codes

Installation must comply with the requirements of all applicable local, state and federal code jurisdictions.

Environmental Consideration

Custom® Building Products is committed to environmental responsibility in both products produced and in manufacturing practices. Use of this product can contribute towards LEED® v3 certification:

  • Up to 1 point towards IEQ Credit 4.3, Low-Emitting Materials - Flooring Systems


All accessories are available with heights and finishes to match PROCOVE A profiles.

  • Left end caps
  • Right end caps
  • Corner pieces
  • Universal connector*

*Universal connector is unfinished, and is not visible once installed

Limitations to the Product

  • For use in interior applications only.
  • Consult CUSTOM technical services for installations in areas where harsh chemicals may be used.
  • Contact CUSTOM technical services for installations in pools and water features.
  • Ambient temperature, surfaces and materials should be maintained at a temperature between 50° F (10° C) and 95° F (35° C) during application.

Application of Product

ProCove A

Measure the thickness of the tile to make sure that the profile will provide proper protection; the upper edge of the profile must always be at the same height or lower (up to 1/32" lower) than the adjacent tile edges. Check the profile for damage – use only undamaged profiles. Use suitable clamps, saws or cutting devices as well as personal protective equipment for cutting and deburring the profile.

Spread thin-set mortar on the substrate where the profile is to be placed with a notched trowel.  Place the stamped fitting strip of the profile into the thin-set mortar and align with the predetermined edge, then cover stamped fitting strip completely with additional thin-set mortar. Make sure to embed the profile in fresh setting material; retrowel or refresh if it has skimmed over prior to the installation of the profile. The tile adjacent to the fitting strip must be placed so it is completely embedded into the thin-set mortar over the stamped fitting strip. The tile should be even or slightly above the edge of the profile.  The space between the profile and adjacent tile should be 1/16" - 1/8" wide.  Make sure that the joint between the floor covering and the profile is completely filled with grout.

End caps, corner pieces and universal connectors should be secured in place with CUSTOM’s 100% Silicone Caulk.

Clean away any mortar or grout residue from the sides of the profile immediately, using clean water and a non-abrading sponge pad or cloth. Do not allow the mortar or grout to dry on the surface of the profile.


Store in a cool dry area.  Protect from damage that may bend or twist the profile.

Product Maintenance

Use TileLab Grout and Tile Cleaner or Aqua Mix Concentrated Stone and Tile Cleaner and a sponge or soft cleaning cloth to clean the surface of the profile. Do not use abrasive cleaners, as they will scratch the surface.

© 2017 Custom Building Products. All Rights Reserved.