Products : Aqua Mix® : Stone Restoration : Aqua Mix® Reviver®

Aqua Mix® Reviver®

A user-friendly, highly-effective, ready-mixed paste for polish restoration and maintenance of worn, calcium-based, polished stone.

  WHERE TO BUY Not all products are sold at all stores. Please call the distributor to ensure product availability.
Have a question?


Key Features

  • Professional polishing compound
  • Re-polishes & restores worn stone
  • Non-acidic formula


Environmental Consideration

Complies with all Federal EPA and SCAQMD standards for VOC.

Suitable Tile Types

Polished limestone, marble, travertine and cement-based precast terrazzo.

General Surface Prep

Test a small area according to application instructions to determine desired results.

Health Precautions

CORROSIVE. CAUSES BURNS. HARMFUL IF SWALLOWED. Wear skin and eye protection. Do not breathe dust. Contains potassium oxalate. If in eyes, flush with water for at least 15 minutes. If on skin, wash with soap and water. If respiratory tract is irritated, move to fresh air. If irritation persists, seek medical attention. If swallowed, DO NOT induce vomiting, seek medical attention. KEEP OUT OF REACH OF CHILDREN.

Limitations to the Product

  • Do not allow product to come in contact with any non-recommended surface
  • May not be suitable for some green marbles
  • Severely damaged or worn polished marble may require professional resurfacing
  • Not intended for use on granite, porcelain, ceramic tile or cultured marble

Application of Product

USE CHEMICAL-RESISTANT GLOVES, such as nitrile, when handling product.

Read entire label before using. MIX WELL before using. Sweep or vacuum surface. Surface to be polished must be free of existing sealers or coatings. Protect baseboards, carpet, etc. with protective plastic and/or blue painters tape. Wet an area no larger than 20 ft (2 M)with clean water and place 2 tablespoons of Reviver® in the center. Using a natural hair or synthetic fiber tan floor pad, work the area in a side-to-side motion with a 175 to 300 RPM floor machine. The consistency of the slurry should be fluid enough to achieve even coverage. If the slurry becomes too dry, add water as required. For large areas, work in small sections and be sure to overlap the sections to achieve an even polish. Continue until the required polish has been achieved - squeegee slurry from a small area to check for desired results prior to removing slurry. Use a wet-dry vacuum to remove slurry and rinse thoroughly. Polish dry with a new polishing pad or cotton bonnet.

Cleaning of equipment

Clean tools with water before material dries.

Handling & Storage

  • Close container tightly after each use
  • Store in original container only
  • Store in and use in temperatures between 45° F to 85° F (7° C to 29° C)
  • Store in areas inaccessible to small children
  • Do not reuse empty container, wrap and discard in trash or recycle

Product Maintenance

Properly applied product requires no special maintenance.

Warranty Information

Product Warranty

Custom® Building Products warrants to the original consumer purchaser that its product shall be free from defects in material and workmanship under normal and proper usage for a period of one year following the date of original purchase. Custom's® sole liability under this warranty shall be limited to the replacement of the product. Some states, countries or territories do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty will not extend to any product which has been modified in any way or which has not been used in accordance with Custom's® printed instructions. Custom® makes no other warranties either expressed or implied. This warranty gives you specific legal rights, and you may have other rights that vary from state to state or from one country/territory to another.  This warranty is not transferrable.

Coverage Chart

SIZE Min Coverage Max Coverage
1 lb (.45 kg) 200 ft² (19 M²) 300 ft² (28 M²)

© 2016 Custom Building Products. All Rights Reserved.