Products : Aqua Mix® : Stone Restoration : Aqua Mix® Renue®

Aqua Mix® Renue®

A polishing cream that restores the shine of dull, etched or lightly scratched polished natural stone. Easy-to-use and no machinery is required.

  WHERE TO BUY Not all products are sold at all stores. Please call the distributor to ensure product availability.
Have a question?

Features/Benefits

Key Features

  • Removes etches & light scratches
  • Restores shine to dull surfaces
  • Easy-to-use

Technical/Installation

Environmental Consideration

Complies with all Federal EPA and SCAQMD standards for VOC.

Suitable Tile Types

Calcium-based polished natural stone (such as limestone, marble, and travertine) and cement-based precast terrazzo.

Health Precautions

CORROSIVE. CAUSES BURNS. HARMFUL IF SWALLOWED. Wear skin and eye protection. Do not breathe dust. Contains potassium oxalate. If in eyes, flush with water for at least 15 minutes. If on skin, wash with soap and water. If respiratory tract is irritated, move to fresh air. If irritation persists, seek medical attention. If swallowed, DO NOT induce vomiting, seek medical attention.

Limitations to the Product

  • Do not allow product to come in contact with any non-recommended surface
  • May not be suitable for some green marbles
  • Severely damaged or worn polished marble may require professional resurfacing
  • Not intended for use on granite, porcelain, ceramic tile or cultured marble
  • For large floor surfaces, Aqua Mix® Reviver is recommended

Application of Product

USE CHEMICAL-RESISTANT GLOVES, such as nitrile, when handling product.

Read entire label before using. SHAKE WELL before using. Surface must be clean, dry and free of existing surface coatings. Apply a small amount (teaspoon or less) of Renue® directly onto etched or worn area. Use spray bottle to apply 1-2 squirts of water directly on Renue®. Using a soft cotton or terry towel, buff Renue® into worn or etched area until slurry becomes clear and nearly dry. Re-wet with water and polish dry completely with absorbent towel. Repeat process if necessary until desired results are achieved. A handheld buffer with soft bonnet may be used for quicker results for larger areas.

Cleaning of equipment

Clean tools with water before material dries.

Handling & Storage

  • Close container tightly after each use
  • Store in original container only
  • Store in and use in temperatures between 45° F to 85° F (7° C to 29° C)
  • Store in areas inaccessible to small children
  • Do not reuse empty container, wrap and discard in trash or recycle

Product Maintenance

Properly applied product requires no special maintenance.

Warranty Information

Product Warranty

Custom® Building Products warrants to the original consumer purchaser that its product shall be free from defects in material and workmanship under normal and proper usage for a period of one year following the date of original purchase. Custom's® sole liability under this warranty shall be limited to the replacement of the product. Some states, countries or territories do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty will not extend to any product which has been modified in any way or which has not been used in accordance with Custom's® printed instructions. Custom® makes no other warranties either expressed or implied. This warranty gives you specific legal rights, and you may have other rights that vary from state to state or from one country/territory to another.  This warranty is not transferrable.

Coverage Chart

SIZE Min Coverage Max Coverage
8 oz (237 mL) Bottle 25 ft² (2.3 M²) 50 ft² (4.6 M²)

© 2016 Custom Building Products. All Rights Reserved.